Relay Module/4 Ch./SSR-ACThe DN-SSR4 relay module can control high voltage load up to 4 A @ 240 VAC, while the DN-SSR4-DC can control DC voltage load up to 4 A @ 50 VDC. Four indicator LEDs, one for each relay, light when their associated relay is activated. Each output of DN-SSR4 equipped with a varistor that shunts the surge voltage of the inductive load or electromagnetic brake to protect the relay contact point. All relay control and relay outputs are accessible through the wiring terminals.
Daughter Board/24DI/CA-5015/DIN/isol.The DB-24P is a 24 channel isolated digital input daughter board for DIO24,DIO48,DIO144 ,PIO-D144,OPTO-22 Compatible digital input board,The optically isolated inputs of the DB-24P consist of a bi-directional opto-couple with a resistor for current sensing . You can use the DB-24P to sense DC signal from TTL levels up to 24V. You can also use DB-24P to sense a wide range of AC signals. The DB-24 P registers a constant logic high if the frequency of the input AC signal is greater or equal to 1 kHz, and if the voltage of the AC signal is at least 4Vrms. If you are using AC input signal ,you must short the AC filter Jumper. You can use the board to isolate the computer from large common-mode voltages ,ground loops, and voltage spikes that often occur in industrial environments.
Daughter Board/Relay/24RO/12V/CA-3710The DB-24R consists of 24 form C, electromechanical relays for efficient switching of load by programmed control . The contact of each relay can control a 0.5 A /110 V load or 1A / 12VDC . The relay is energized by applying a 5 voltage signal to the appropriate relay channel on the 50-pin Opto-22 compatible connector or D-Sub 37 connector . Twenty-four enunciator LEDs, one for each relay, light when their associated relay is activated . To avoid overloading your PC’s power supply, this board needs a +12VDC or +24VDC external power supply.
Daughter Board/A-82X/37pin/PCI-1800/CA-3710/1m/DINFemale DB37 to Screw Terminal Board for A-82X series, PCI-1800U (DIN-rail Mounting)Include: CA-3710 (DB37 Male to Male, 45º, 1M)
Relay Module/4 Ch./SSR-AC/DINThe DN-SSR4 relay module can control high voltage load up to 4 A @ 240 VAC, while the DN-SSR4-DC can control DC voltage load up to 4 A @ 50 VDC. Four indicator LEDs, one for each relay, light when their associated relay is activated. Each output of DN-SSR4 equipped with a varistor that shunts the surge voltage of the inductive load or electromagnetic brake to protect the relay contact point. All relay control and relay outputs are accessible through the wiring terminals.
€95.00*
Easy ordering via online shop
Directly from manufacturer
Europe-wide shipping
personal consultation
Request sent successfully
Request wasn't send - a error occured. Please try again.